INSTALLATION AND USER MANUAL WRC313S Rangehood WRCG933S Canopy Rangehood WRFG943S Canopy Rangehood
CONGRATULATIONS CONTENTS Congratulations and thank you for choosing our canopy rangehood. We are sure you will find your new rangehood a pleasure to use. Before you use your rangehood, we recommend that you read through the whole user manual, which provides the description of the rangehood and its function.
IMPORTANT SAFETY INSTRUCTIONS This manual explains the proper use of your new Westinghouse canopy rangehood. Please read this manual carefully before using the product. This manual should be kept in a safe place for handy reference. This canopy rangehood is a domestic appliance which has been manufactured and tested to comply with Australian and New Zealand Standard AS/NZS 60335.2.31.
DESCRIPTION OF YOUR RANGEHOOD WRC313S WRCG933S WRFG943S 1 1 1 2 2 2 3 3 4 4 5 5 6 6 7 7 3 4 5 7 Fig. 3 Components list 1. Upper Flue mounting bracket - - - 2. Telescopic flue cover - - - - - - - - 3. Flue transition duct - - - - - - - - - 4. Lower Flue mounting bracket - - - - 5. Main body and fan housing assembly 6. Glass (not applicable to WRC313S) 7. Grease filter - - - - - - - - - - - - - - - - - - - - Qty.
RANGEHOOD DIMENSIONS WRC313S 290 600 Min 600 / Max1100 320 216 290 296 320 Fig.
RANGEHOOD DIMENSIONS WRCG933S 320 WRFG943S 320 290 290 480 480 90 900 320 296 35 320 Fig. 5 6 216 290 600 Min 600 / Max1100 600 Min 600 / Max1100 900 216 290 296 Fig.
INSTALLATION PRE-INSTALLATION Before installing the cooker hood, peel off any protective coating. LOCATION The hood is to be mounted on the wall. When installed, the hood must be not less than 60cm above electric burners or 65cm above gas or mixed-fuel burners.
INSTALLATION 3. Install flue cover wall mounting brackets with suitable fixings. Install suitable screws for rangehood mounting points (to support a total weight of 30kg) to the wall as marked (Fig. 7). 5. Fix exhaust transition duct using screws supplied (Fig. 10). B A B Fig. 10 6. Hang the body hood on the mounting screws then secure at the anti-tilt locations as indicated in Fig. 7 & 8. 2mm Fig. 8 4.
INSTALLATION Depending on the preferred installation/ducting mode, follow step 7a or 7b below. 7a.Recirculating mode (Fig. 12). Using the centre line, secure the recirculating T-piece to the wall with suitable screws/fixings (optional kit AR910RK). Install flexible pipe between T-piece and the exhaust transition duct. Use cable ties or suitable duct tape to secure flexible pipe to T-piece and transition duct (Fig. 14).
INSTALLATION 8. Electrical connection Check that the installation complies with the standards of local building, gas and electrical authorities. Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate inside the rangehood. 10. (Only for model WRCG933S and WRFG943S) Insert the glass into the slot on the main body as show in Fig.17, then pull the latchs to inner side, same time push the glass in place (Fig.18).
CONTROL PANEL CARE & MAINTENENCE • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. • Turn the hood on for a few minutes before you start cooking. • The hood should be left on for a minimum of 5 minutes after cooking or until all odours have dispersed. • The control switches are located on the front panel of the unit. See Fig. 19 below. A B C D E F G Fig. 19 A.
CARE & MAINTENENCE Hand washing Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. Repeat the process if necessary. Refit the grease filters when they are dry. Dishwasher Place grease filters in the dishwasher. Select the most powerful washing program and highest temperature, at least 65°C. Repeat the process. Refit the grease filters when they are dry.
TROUBLESHOOTING GUIDE PROBLEM The cooker hood will not start REMEDY Check that the hood is connected to an electrical supply Check that a fan speed has been selected Check that the fan speed is set high enough for the task The grease filters are clean The kitchen is adequately vented to allow the entry of fresh air The cooker hood is not working If set up for recirculation, check that the charcoal filter is still effective If set up for extraction, check that the ducting and outlets are not blocked Do no
OPTIONAL DUCTING ACCESSORIES AR150RC AR150F AR610FS AR150WV AR910RK AR610CF Part Numbers Description AR150RC 150mm G/Bond Roof Cowl AR150F 150mm G/Bond Flue 1200mm AR150WV 150mm Wall Vent & duct AR910RK Recirculating Kit (150-120mm reducer, T-piece & carbon filters AR610CF Replacement carbon filter AR610FS Stainless steel exhaust cover extension 1200mm 14
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: RANGEHOOD This document sets out the terms and conditions of the product warranties for Electrolux Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Appliance. 1.
For more information on all Westinghouse appliances, or for dimension and installation information, call into your retailer, phone or email our customer care team or visit our website: AUSTRALIA phone: 1300 363 640 fax: 1800 350 067 email: customercare@electrolux.com.au web: www.westinghouse.com.au NEW ZEALAND phone: 09 573 2384 fax: 0800 363 600 email: customercare@electrolux.co.nz web: www.westinghouse.co.
