Installation Guide

9DOOR ALIGNMENT
ADJUSTING DOOR ALIGNMENT
Tighten all the
screws
Tension screw
Self tapping screw
Tighten all
screws
Self tapping
screw
Extract the
tensioner
Fit bottom first
Lift top-front
bracket
Slide centre
cover under
Tensioner
screw
Tighten all
screws
Self tapping
screw
Extract the
tensioner
Fit bottom first
Lift top-front
bracket
Slide centre
cover under
Tensioner
screw
Tighten all
screws
Self tapping
screw
Extract the
tensioner
Fit bottom first
Lift top-front
bracket
Slide centre
cover under
Tensioner
screw
To complete installation of your joined appliances it may
be necessary to slightly adjust door alignment on the
individual appliance. This process is illustrated in the
following section.
1. With the door open, remove the hinge cover by
simultaneously pulling the cover away and up from
the hinge. This action will release the clip that is
retaining the cover to the hinge.
2. Slightly loosen the three screws retaining the hinge
to the cabinet. This will allow for slight movement of
the cabinet door. Have the assistant hold the door in
desired position and fully secure top hinge fasteners,
inspect the alignment and if satisfied clip the hinge
cover back onto the top hinge.
Small plastic clip is located here. With the door
open, pull the cover outward while simultaneously
pulling up in order to release the hinge cover.
Loosening the top hinge fasteners will allow the
top hinge to be slightly rotated thus adjusting the
gap between doors.