Installation Guide

7INSTALLATION
Required Tools
• 3mm Allen key
• Phillips head screwdriver
• 7mm socket wrench screwdriver
Preliminary Operations – General Preparation
• Before starting to bring the appliances together, in
order to protect the sides from possible damage
during the installation process, attach the four
disposable protective foam pads at the facing side
corners of one of the appliances (foam should be
applied to the handle side of the cabinet as shown
with approximately 100mm from the front or back
and 300mm from the top or bottom).
Remove the factory
fitted base
Select the supplied base
(item 5) in the kit
Fit to cabinet
Ensure the hole is nearest the
outside edge of the cabinet
Perform these steps on both cabinets
300mm
100mm
300mm
100mm
• Pull the appliances together.
• Adjust the front feet of the appliances to the same
height and alignment.
Replace Foot Bases
NOTE: Two people may be required for this operation
• Remove the two front feet that will meet in the
middle then remove the factory fitted base, discard
and replace with the foot base part (item 5) supplied
in the kit ensuring that the M4 threaded hole is facing
the front and is nearest the outside edge of the
cabinet.
Fitting rear levelling feet
NOTE: Two people may be required for this operation
A set of adjustable back feet is provided with the kit.
These parts are usually needed only in the case of a
particularly
uneven floor and when height adjustments in phase 1.2.1
proved unsuccessful.
• Temporarily remove the screws holding the
evaporator tray.
• Temporarily remove the 2 cabinet screws that will
hold the foot.
• Pre-assemble the two nuts on the foot.
• While one operator is lifting the appliance the other
can assemble the foot.
• Assemble right foot using the two cabinet screws
that have previously been removed and the two bolts
that come with the foot.
• Repeat the process for the other side.
100mm
100mm
300mm
Ensure the hole is nearest
the outside edge of the
cabinet
Remove the
factory
fitted
base
Select the supplied
base (item 5) in
the kit
Perform these steps
on both cabinets
Fit to cabinet
300mm
INSTALLATION