Manualshelf

Use and Care Manual

ManualsBrandsWestinghouse ManualsAir Conditioners7,200 BTU Portable Air Conditioner Cools 550 Sq. Ft. with 3-in-1 Operation in White
12345678910
10 | English
ASSEMBLY
A - Hose Outlet
B - Exhaust Hose
A - Hose Inlet
B - Exhaust Hose
C - Groove
A - Fixed Panel
B - Sliding Panel
C - Opening
lPlace the hose outlet on the end of the exhaust hose
and turn clockwise to secure.
lSlide the hose inlet into the grooves on either side of the
exhaust duct.
lApply slight downward pressure on the hose inlet until
the latch snaps into place and the hose is secure.
lRoute the other end of the exhaust hose to the window
vent kit.
FIG. 6
FIG. 8
FIG. 7
B
A
A
B
A
C
B
C
B
INSTALLING THE WINDOW VENT KIT
See Figures 9 - 15.
The following tools are recommended for installation, but
are not included with the product: Phillips screwdriver,
tape measure, knife, hacksaw, and foam seal (adhessive).
The Window Vent Kit will t inside most standard vertical
and horizontal windows, however, you may need to add
or cut panels for certain types of windows. If the kit is not
wide enough for your window, you can purchase additional
panels by contacting customer service. If the kit is too
wide for your window, you can cut the xed panel to the
appropriate size. Do not cut the end of panel with the
opening.
lUnplug the air conditioner.
lOpen the window and measure the width or height
inside the window frame.
lCut the foam seal (adhesive type) to the proper length
and attach it to your horizontal (or vertical) sliding
window.
FIG. 9
A
B
A - Foam Seal (Adhessive)
B - Width