User Manual

INSTALLATION (CONTINUED)
• Electrolux Home Products cannot accept
responsibility for damage caused by installation
into low temperature tolerant cabinets.
• After installation, test and ensure that the appliance
operates correctly before handing it over to the
customer.
To avoid any potential hazard, you must follow our
instructions when you install your appliance. Failure
to install the appliance correctly could invalidate any
warranty or liability claims and lead to prosecution.
• Put the appliance far away from steam, hot air
and water splashes.
• If the appliance is stored/ transported at sub-zero
temperatures, do not activate it immediately after
installation. Allow at least two hours for it to be
brought up to room temperature before turning on
the unit.
Blocking the intake or outlet vents can damage the oven.
If air vents are blocked during operation, the oven may
overheat, and this may lead to malfunctioning. Hot air
escapes from the vents, so be sure not to obstruct it or
let curtains come between the oven and the rear wall.
• Place the oven as far away from radios and TV
as possible. Operation of the oven may cause
interference to your radio or TV reception.
• When there is interference, it may be reduced or
eliminated by taking the following measures:
- Clean door and sealing surface of the
microwave oven.
- Reorient the receiving antenna of the radio
and/or television.
- Move the microwave oven away from the
receiver.
- Plug the microwave oven into a different outlet
so that microwave oven and receiver are on
different branch circuits.
• Be sure the voltage and frequency where you
connect the microwave oven is the same as specified
on the rating plate on the microwave oven. If the
microwave oven is connected to the socket via an
extension cord, make sure the cord is earthed.
WARNING
WARNING
This microwave oven must not be used on a non-earth
protected power supply. Contact an electrician if you are
uncertain regarding electrical connection of the oven or
provision of earth protection of the supply.
WARNING
WARNING
If the power cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
ELECTRICAL INSTALLATION
WARNING
WARNING
Only a qualified person must do the electrical installation.
TIPS & INFORMATION
IMPORTANT
The manufacturer is not responsible if you do not follow
the safety precautions from the chapter “Safety
Instructions”.
This appliance is supplied with a supply cable only.
WARNING
WARNING
The electrical installation must have an isolation device
which lets you disconnect the appliance from the mains
at all poles. The isolation device must have a contact
opening width of minimum 3mm.
17INSTALLATION