User Manual

16 17
INSTALLATION ASSEMBLY INSTALLATION
CAUTION!
Do not block the air vents. If you do that, the appliance
can overheat.
CAUTION!
Do not connect the appliance to adapters or extension
leads. This can cause overloading and risk of fire.
• The fitted cabinet must not have a back wall behind
the appliance.
• Put the appliance far away from steam, hot air and
water splashes.
• If the appliance is stored/transported at sub-zero
temperatures, do not activate it immediately after
installation. Allow at least two hours for it to be
brought up to room temperature before turning on
the unit.
Installation - Built-in model
For the best integration within a kitchen, install this
appliance in a standard 600mm wide cupboard that gives
a flush fit with the surrounding cupboard fronts. A recess
of 20mm is ideal.
The built-in cabinet must not have a rear wall behind
the appliance. Do not cover ventilation slots and air
intake points.
NOTE: Your appliance must be mounted on a flat surface
for the full width and depth of the product.
Where the appliance is built into a cabinet, the cabinet
must be capable of withstanding 70°C. Installation into
low temperature tolerant cabinetry (e.g. Vinyl coated)
may result in deterioration of the low temperature coating
by discolouring or bubbling.
• If the appliance is to be installed adjacent to vinyl
wrapped surfaces, use an installation kit available
from the vinyl-wrap supplier.
• The manufacturer cannot accept responsibility for
damage caused by installation into low temperature
tolerant cabinets.
1. Carefully turn over the unit and place onto a bench
with a towel to prevent damage. Screw in the four
bottom feet as shown.
2. Carefully turn over the unit so it is the right way up.
3. Place the trim supplied around the microwave
ensuring vent holes are at the top. Use two 4 x10
screws on the left hand side ensuring the trim is
flush with the front face of the microwave.
4. Fix the other side using the screws and washers
provided.
5 Make sure gap A = gap B= 2mm, if not adjust the feet
to level.
6 The front edge of the trim kit holder brackets need
to be fastened 45mm from the front face of your
cabinet. A positioning card (the folded cardboard
piece included in the plastic bag with this user
manual) is provided as a template to correctly locate
the trim kit holder brackets.
• The short side needs to be flush with the front of
the cabinet.
• Align the side edge of the bracket with the edge of
the card.
• Align the bottom edge of the bracket with the
cabinet floor.
• Mark the position of the holes with a pencil.
Fix the brackets in place using the screws provided.
The trim kit with some holes
side on the top.
Parts included for assembly
NO.
NAME QTY
1 Microwave oven 1
2 Bottom feet 4
3 trim kit 1
4 Screw 4x16 6
5 Screw 4x10 and washers 4
6 Trim kit holder brackets 2
7 Positioning card 1
1
7
2
4
3
6
5