User Manual

18 19
Built-in furniture – flush fit
600mm
464mm
(+2)
Min.
550mm
45mm
A 45mm ventilation gap must be left between the built-in
cabinetry and wall with no back panelling on the cabinet
housing the microwave.
Side view
45mm
microwave
oven
External face
of cabinet
and/or door
ELECTRICAL INSTALLATION
WARNING!
Only a qualified person must do the
electrical installation.
The manufacturer is not responsible if you do not
follow the safety precautions from the chapter
“Safety Instructions”.
This appliance is supplied with a main cable and
main plug.
WARNING!
The microwave is fitted with a plug and must be only
connected to a properly installed, earthed socket.
In accordance with the appropriate regulations, the
socket must only be installed and the connecting cable
must only be replaced by a qualified electrician. If the
plug is no longer accessible following installation an all-
pole isolating switch must be present on the installation
side with a contact gap of at least 3mm.
• Place the microwave as far away from radios and TV
as possible. Operation of the microwave may cause
interference to your radio or TV reception.
• Be sure the voltage and frequency where you
connect the microwave is the same as specified on
the rating plate on the microwave. If the microwave is
connected to the socket via an extension cord, make
sure the cord is earthed.
WARNING!
If installed near or over a heat source, the microwave
could be damaged.
WARNING!
This microwave must not be used on a non-earth
protected power supply. Contact an electrician if you are
uncertain regarding electrical connection of the oven or
provision of earth protection of the supply.
WARNING!
If the power cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
7. Push the microwave with trim assembly fitting into
the cut-out. The trim kits is fitted with strikers that
locate into brackets. When pushed in far enough the
trim will snap into place in four locations, fixing the
microwave in the cabinet.
8. Check the gaps with the unit installed.
If gap C is different to gap D, go back to step 5.
If gap E is different to gap F, move the unit left or right
to adjust.
Gap E
(Trim kit to
cabinet)
Gap F
(Trim kit to
cabinet)
Gap C
(Trim kit to
cabinet)
Gap D
(Trim kit to
cabinet)