USER MANUAL MICROWAVE OVEN WMB2522SC
CONGRATULATIONS CONTENTS Dear customer, General warnings.................................................................................3 Congratulations on the purchase of your new microwave. Important safety instructions........................................................ 4 Before you use the microwave, we recommend that you read through the whole user manual which provides the description of the microwave and its functions. Utensils.............................................................
GENERAL WARNINGS lease read the user manual carefully and store in a handy P place for later reference. Pass the user manual on to possible new owners of the appliance. • When heating food in plastic or paper containers, keep an eye on the appliance due to the possibility of ignition. Read the following carefully to avoid damage or injury. • The appliance is intended for heating food and beverages.
SAFETY INSTRUCTIONS Installation Care and cleaning WARNING WARNING Risk of injury, fire or damage to the appliance. • Be sure to unplug the appliance from the power supply before cleaning. Remove all the packaging. • Do not install or use a damaged appliance. • Obey the installation instructions supplied with the appliance. • Always be careful when you move the appliance because it is heavy. Always wear safety gloves. • Keep the minimum distance from the other appliances and units.
PRODUCT DESCRIPTION 1 6 5 4 3 1 Control panel 2 Turntable shaft 3 Turntable ring assembly 4 Glass tray 5 Observation window 6 Door assembly 7 Safety interlock system 2 7 TURNTABLE INSTALLATION Hub (underside) • Never place the glass tray upside down. The glass tray should never be restricted. • Both glass tray and turntable ring assembly must always be used during cooking. • All food and containers of food are always placed on the glass tray for cooking.
OPERATING INSTRUCTIONS Clock Setting When the microwave oven is electrified, the screen will display “0:00” and the buzzer will ring once. 1. Press Clock/Kitchen Timer once to select clock function. The hour figures will flash. 2. to adjust the hour figures. The input time Turn should be within 0 and 23. 3. Press Clock/Kitchen Timer. The minute figures will flash. 4. to adjust the minute figures, the input time Turn should be within 0 and 59. 5. Press Clock/Kitchen Timer to finish clock setting.
OPERATING INSTRUCTIONS (CONTINUED) Auto Menu The menu chart: 1. Turn right to choose the menu, and “A-1” to “A-10” will display. MENU WEIGHT DISPLAY 2. Press Start/+30Sec./Confirm to confirm. A-1 Pizza 200g 200 3. to choose the default weight as per the Turn menu chart. 400g 400 200g 200 4. Press Start/+30Sec./Confirm to start cooking.
UTENSILS Utensil Test WARNING WARNING It is hazardous for anyone other than a competent person to carry out any service or repair operation that involves the removal of a cover which gives protection against exposure to microwave energy. See the instructions on “Materials you can use in microwave oven or to be avoided in microwave oven.” There may be certain non-metallic utensils that are not safe to use for microwaving. If in doubt, you can test the utensil in question following the procedure below. 1.
TROUBLESHOOTING WARNING WARNING Refer to the safety chapters. PROBLEM POSSIBLE CAUSE REMEDY The appliance does not operate. • Power cord not plugged in tightly. • Unplug, then plug in again after 10 seconds. • Fuse blown or circuit breaker tripped. • Reset the circuit breaker or check and replace the fuse. If the fuse blows or circuit trips more than once, contact a qualified electrician. • Faulty wall power outlet. • Test the outlet with other appliances.
INSTALLATION WARNING CAUTION The oven is fitted with a plug and must only be connected to a properly installed earthed socket. The socket must only be installed and the connecting cable must only be replaced by a qualified electrician, in accordance with the appropriate regulations. If the plug is no longer accessible following installation, an all-pole isolating switch must be present on the installation side with a contact gap of at least 3mm.
INSTALLATION (CONTINUED) 600m m 00 n.5 Mi 466mm+2 600m m mm 50 n= i m 6mm packer External face of cabinet and/or door 20mm Please note packer must be set back 20mm from front trim to avoid obstruction of front vent. Packer must be secured to base of cabinet. microwave oven Min 3.
INSTALLATION (CONTINUED) Screw A Screw B Mounting plate Trim kit plastic cover Positioning marking using the supplied template 1. Read the instruction on the BOTTOM CABINET TEMPLATE and place the template on the bottom plane of cabinet. Holes ""a" PN:261800316968 2. Make the marks on the bottom plane of cabinet according to marks”a” of the template. a a Centre line 3. Remove the bottom cabinet template and fix the mounting plate with screw A.
INSTALLATION (CONTINUED) Installing the oven 1. Insert the oven into the cabinet, making sure the back of the oven is locked by the mounting plate. Do not trap or kink the power cord. Mounting Plate 2. Open the door and fix the oven to the cabinet with Screw B, at the installation hole. Then fix the Trim-kit plastic cover to the installation hole.
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: WESTINGHOUSE SOLO MICROWAVES (ii) misuse or abuse, including failure to properly maintain or service; This document sets out the terms and conditions of the product warranties for Westinghouse Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should there be a manufacturing defect in your Appliance.
For more information on all Westinghouse appliances, or for dimension and installation information, call into your retailer, phone or email our customer care team or visit our website: AUSTRALIA phone: 13 13 49 email: customercare@electrolux.com.au web: westinghouse.com.au NEW ZEALAND phone: 0800 10 66 10 email: customercare@electrolux.co.nz web: westinghouse.co.nz Westinghouse. We are part of the Electrolux family. Share more of our thinking atelectrolux.
