User manual

INSTALLATION

WARNING

Step 3: Stability bolt

1. Remove oven door – to be done by qualified personnel

only. (Refer to procedure).

2. Remove screws from kick panel. To remove kick panel

lift kick panel upwards to release the two Location Tabs

from the holes in the bottom of the panel.

3. Position the cooker into the anti-tilt bracket.

4. Remove the tape from the stability bolt.

5. Rotate the stability bolt 180˚ clockwise until it is

pointing to the left like the picture below.

6. The stability bolt should now be able to drop to

the floor.

7. Mark the position for the stability bolt on the floor.

8. Pull the cooker out and drill the bolt hole, using a

6.5mm masonry or wood drill. Minimum 30mm deep

for concrete.

9. Reposition the cooker back into place, then fit the

stability bolt into the drilled hole.

Stability bolt

Kick panel

ø6.5mm drilled

location hole

Front adjustable feet

TIPS & INFORMATION

IMPORTANT

Setting the time

If you have purchased a model fitted with an electronic

or programmable clock, you MUST set the time of day

before you can operate your appliance.