User manual

ManualsBrandsWestinghouse ManualsKitchen AppliancesWLE624WA

INSTALLATION

Plastic clip

securing points

WARNING

This appliance must be installed by an authorised person in

compliance with local municipal building codes and any

other relevant statutory regulation.

Wiring connections must be made in accordance with:

New Zealand & Australian requirements, including

AS/NZS 3000 WIRING RULES.

Refer to data plate for rating information. The data plate is

positioned on the bottom of the oven front, viewable with

the oven door open. The circuit diagram is positioned on

the control panel back cover.

• Electrical connection is 230–240 volts AC 50 Hz.

• To gain access to the mains connection terminals,

remove the rear cover by unscrewing the two

assembly screws.

• The cooker requires a means of all pole disconnection

incorporated into the fixed wiring. This MUST have a

disconnection gap of 3mm.

• The cooker MUST be earthed. Any damage caused by

failure to earth will not be covered by warranty.

NOTE: Where connection is made to a multi-phase

220/240V supply, the bridge piece must be removed from

between the active connections on the main terminal block.

Fuse (for New Zealand only)

Should the fuse need servicing it is accessible through

the fuse opening located in the back cover.

The Cooking range must be connected to the supply by a

supply cord fitted with the appropriately rated plug with the

socket-outlet fitted to the final sub-circut in the fixed wiring

that is intended to supply this cooking range.

See table below.

Supply cord specifications

MODEL CURRENT

RATING

(AMPS)

WIRE

SECTION

(MM

)

MINIMUM

TEMP

RATING

(°C)

WLE620WA

25 2.5 75

WLE622WA

32 4.0 75

WLE624WA

32 4.0 75

WLE625WA

32 4.0 75

WLE626WA

32 4.0 75

WLE644WA

32 4.0 75

WLE645WA

32 4.0 75

WLE646WA

32 4.0 75

Hard wiring detail

1. Remove terminal cover plate from rear panel

of appliance.

2. Fit wires through hole in cover plate and make

connections to terminals.

3. Engage wires into plastic clip. Secure plastic clip with

two long silver screws (supplied in separate bag).

4. Replace cover plate onto rear panel.