User Manual

INSTALLATION

Stabilising bolt

Front

adjustable

feet

Stability

bolt

6.5mm Ø

drilled

location hole

Kick panel

1� Remove oven door - to be done by qualified personnel only�

(Refer to procedure)�

2� Remove screws from kick panel� To remove kick panel lift

kick panel upwards to release the two location tabs from

the holes in the bottom of the panel�

3� Position cooker into the ant-tilt plate and then mark the

position for the stability bolt hole on the floor�

4� Pull cooker out and drill the bolt hole, using a 6�5mm

masonry or wood drill bit� The bolt hole needs to be a

minimum of 30mm deep when fixing the oven to concrete�

5� Reposition cooker back into place and fit the stability

bolt through the slot and into the drilled hole�

6� If the cooker is placed on a base, measures must be

taken to prevent the appliance slipping from the base�

7� Carefully remove any protective plastic film to prevent

damage to the appliance�

WARNING

For your safety this cooker is designed to be moved out of

position by a qualified person only�

WARNING

Ensure the appliance is switched off at power supply (not just

the control knobs) before replacing the light globe to avoid

possibility of electric shock�

Turn oven light glass

anti-clockwise to

remove it for globe

replacement

A special high temperature resistant globe should be used�

This can be purchased from the Electrolux Customer Care

Centre�

Light globes are not covered by warranty�

REPLACING THE OVEN LIGHT