User Manual

ASSEMBLING THE VACUUM CLEANER

1. Before assembling the vacuum cleaner, mount

the included wall-mounted storage unit to the

wall. Ensure it is mounted high enough to

allow the vacuum cleaner to rest on the wall-

mount at full height.

Place the mount against the wall and using the

wall unit mounting holes as a guide, mark the

wall where the wall plugs (brick only) will be

drilled and inserted. Drill holes into the wall

and insert the wall plugs. Line up the wall-mount

unit holes with the drilled inserted plugs and

insert the screws into the wall plugs. Tighten

using a Philips head screw driver. (Drywall ﬁxings

not supplied)

2. Once fully charged, slide the battery into the

vacuum cleaner body. When successfully installed,

the battery will "click" into place.

3. Insert the power brush into the base of the

conductive metal tube by clicking it into place.

Then insert the conductive metal tube into the

vacuum cleaner body. When successfully

installed, the parts will "click" into place.

4. If using the power brush without the conductive

metal tube, simply attach it to the vacuum

cleaner body. When successfully installed, the

parts will "click" into place.

5. When attaching accessories, refer steps 1-4 above

and substitute the reference to the power brush

with the accessory in question. Use the upholstery

nozzle to vacuum fabric furnishings such as sofas,

armchairs and curtains. Use the crevice nozzle to

vacuum narrow spaces such as corners and hard

to reach areas.

Conductive tube