Installation Manual

OPERATION
1
Vacuum Cleaning
Please reference page 3 for part number references mentioned in the below
instructions.
. Before using the device first roll out a sufficient length of electric flex cable
and plug into the mains socket. The yellow mark on the electric flex cable is
the maximum length that must not be exceeded. To switch on the device
press the ON/OFF button (7).
2. To rewind the power cable, press the cord rewinder button (10) with one
hand and guide the cable with the other hand to ensure the cable does not
whip causing damage.
1
Emptying the dust container
NOTE: Empty the dust container when the quantity of dirt in the dust container
has reached the “MAX” mark or the suction power has decreased.
. Switch off the vacuum cleaner and disconnect the plug from the mains.
Always pull on the plug and not on the cable.
2. Release the dust container by pressing the release button (9).
3. Lift the dust container out of the vacuum cleaner in an upward motion.
4. Hold the dust container low over a dustbin, push the lid release button and
open the dust container lid.
5. Empty the dust into the dustbin and close the dust container lid.
6. Place the dust container back into the vacuum cleaner body and ensure
the container is firmly seated.
6