User Manual

12 13INSTALLATION OF THE APPLIANCE INSTALLATION OF THE APPLIANCE
Freestanding installation (continued)
• Connect services to the appliance prior to placing
into cavity.
• To locate appliance, slide into cavity ensuring the
anti-tilt brackets fully engaged with the rear left and
right engagement slots.
• The unit must be pushed against the wall
on installation.
• Re-install oven door, burner body, burner caps and
trivets after the appliance is placed in the cavity.
• Gas only: check that the gas hose, if used, has not
been kinked during installation.
Installing the clip-on kick panel
Models WFE915SD, WFE916DSD, WFE946SD &
WFEP917DSD are supplied with a clip-on kick panel
that can be assembled to clip onto the front feet for a
more integrated and seamless kitchen appearance.
Clip base
Clip snap
Assemble the clip snap onto the base.
click!
Press in both assembled clip modules into the
kick panel in the orientation as shown below.
click!
Freestanding installation (continued)
WARNING
WARNING
• Appropriate fasteners must be used to suit the type
of wall on which the anti-tilt brackets are installed.
• Freestanding unit must be pushed up against
the wall on installation. On gas units check that
the gas hose, if used, has not been kinked during
installation.
4. The anti-tilt brackets must be secured to the
rear wall of the cavity with appropriate fasteners
according to dimensions in diagram.
Install anti-tilt brackets
in this orientation as
shown (fasteners not
supplied)
C
L
425
Anti-tilt bracket
installation
reference line
725
370 370
INSTALLATION OF THE APPLIANCE (CONTINUED)