User Manual

8 9INSTALLATION OF THE APPLIANCE INSTALLATION OF THE APPLIANCE
Freestanding installation (continued)
Installation of screw-in feet
• Freestanding appliance are supplied with four
screw-in feet in the internal accessory pack.
The screw-in feet can be adjusted by turning the
lower half clockwise or anti-clockwise.
TIPS & INFORMATION
IMPORTANT
• WFE904SD is supplied with two silver feet and
two black feet, it is recommended to install the two
sliver feet at the front of the appliance for the best
aesthetics.
• If the appliance is a gas hob model, remove the
burner cap and burner crown. Store all items safely,
away from the installation area.
You MUST remove the oven door before commencing
installation
Locking tab up at normal position
Locking tab up at normal position.
Press the locking tab down for
removing the door.
Gently close the door until it comes to
a stop.Then lift the door off the hinge.
Press the locking tab down for removing the door.
Locking tab up at normal position.
Press the locking tab down for
removing the door.
Gently close the door until it comes to
a stop.Then lift the door off the hinge.
Gently close the door until it comes to a stop. Then lift
the door off the hinge.
Tilt and carefully lay the appliance on its back to gain
access to the installation point for the screw in feet.
WARNING
CAUTION
• To avoid scratching the floor and the appliance
itself, fold the packaging carton board and place
it underneath the appliance as protection.
• The cooker MUST be laid on its back when
installing the feet.
Put the oven door handle protection
foam underneath the laid down cooker to
protect your cooker when puting it upright
Install the four supplied feet via the four installation
points. Make sure that each foot is securely fastened.
WARNING
CAUTION
Do not over-torque the foot.
Adjust the height of the screw-in feet to make sure the
hob surface is 10mm above the bench when appliance
is upright.
Freestanding installation
Cabinet construction for freestanding installation
The freestanding type installation requires four screw-in
feet to be installed before it can be fitted in between
cabinets, with cabinets on one side or without adjacent
cabinets. There is no clearance requirement to adjacent
side cabinets.
To ensure cooker stability, the anti-tilt brackets must
be installed.
Four screw-in feet are supplied with the appliance and
can be found in the accessories pack in the oven.
WFE915SD, WFE916DSD, WFE946SD & WFEP917DSD
are supplied with a clip-on kick panel.
900mm minimum
755mm NOM
900mm NOM
600mm
both sides
INSTALLATION OF THE APPLIANCE (CONTINUED)