USER MANUAL SINGLE DOOR FREEZER WFB2804S, WFB2804W
CONGRATULATIONS CONTENTS Dear customer, General warnings.................................................................................3 Congratulations on the purchase of your new freezer. Important safety instructions........................................................ 4 Before you use the freezer, we recommend that you read through the whole user manual which provides the description of the freezer and its functions. Installing your freezer....................................................
GENERAL WARNINGS lease read the user manual carefully and store in a handy P place for later reference. Pass the user manual on to possible new owners of the appliance. Read the following carefully to avoid damage or injury. Note! You must read these warnings carefully before installing or using the appliance. If you need assistance, contact your Customer Care Department.
GENERAL WARNINGS Read the following carefully to avoid damage or injury It is important to use your freezer safely. Check these safety points before using your freezer. • Keep ventilation openings in the appliance enclosure or in the built-in structure clear of obstruction. • When installed correctly, your freezer should: - Have adequate space at the back and sides for air circulation (refer to page 6). • The appliance must be plugged into its own dedicated 220-240V, 50Hz AC electrical outlet.
PRODUCT DESCRIPTION 12 1 13 2 14 3 15 4 16 5 6 7 8 9 10 17 11 18 1 Upper door cover 7 2 Corner cover 8 Middle freezer drawer 14 Control panel 3 Flap cover 9 Freezer drawer 15 Glass shelf 4 Ice tray 10 Lower freezer drawer 16 Narrow drawer 5 Ice box 11 17 Cabinet 6 Upper freezer drawer 12 Hinge cover Handle (back) Freezer gasket 13 Block cover 18 Adjustable bottom feet Note! Your freezer may differ slightly from this illustration but the functions and operation wil
INSTALLING YOUR FREEZER Adequate ventilation around your freezer. The diagram below shows the recommended airspace to allow for ventilation of your freezer. Your new freezer should arrive with the front adjustable rollers wound down, to tilt the top backwards by about 10mm from upright. This will allow your freezer door to self-close, providing a consistent closed seal.
INSTALLING YOUR FREEZER 4. Check the alignment of the freezer to the surrounding cupboards to see if it is level. You can adjust the level with the rollers as detailed in step 3. aligned to cupboards ie. even gap top of freezer is level ie. horizontal 8. When you have the appliance in its final position, it needs to be stablisied. Wind the stability foot down to the floor until it just makes contact with the floor.
REVERSING THE DOOR If the position your fridge occupies would be better suited to a reverse opening arrangement, carefully follow these diagrams and instructions. The reversing of doors or replacement of light bulbs is not covered by warranty. 3. Using the 8mm wrench, unscrew and remove the hinge axis. hinge axis Tools you will need: • • • • 8mm socket driver Cross-shaped screwdriver Putty knife or thin-blade screwdriver 3mm allen key 4. Flip the upper hinge over as shown below. 5.
REVERSING THE DOOR (CONTINUED) 8. Change handle to the desired side and reinstall it as shown below. 10. Unscrew the washers and remove the lower hinge axis from the far hole and screw it into the near hole as per the picture below. Replace the washer. washer hinge access 9. Detach door stopper and limit block as shown and reinstall on the opposite side of the door. 11. Swap the positions of the the front foot fixed board and the right lower hinge and re-attach.
REVERSING THE DOOR INITIAL START-UP 13. Move the freezer door to the correct position next to the cabinet and attach with the upper hinge. Screw the hinge into place then fix with the hinge cover (supplied). Freezers work by transferring heat from the food inside to the outside air. This operation makes the back and sides of the freezer (particularly at start-up) feel warm – which is normal. upper hinge hinge cover A cooling coil is located behind the rear wall of the freezer section.
ELECTRONIC CONTROLS All functions and controls of the freezer are accessible from a control panel conveniently located on the roof of the cabinet. A display circuit board allows easy configuration of features and settings in a simple and intuitive manner. IMPORTANT TIPS & INFORMATION When the freezer is turned on, all the pilot lights will turn on for 3 sec and you will hear a long “beep”. The display board consists of four buttons and eight pilot lights.
FEATURES OF YOUR FREEZER Features Freezer drawers This section tells you how to make the most of the many useful features - cleaning instructions can be found on page 13. To access the freezer drawers, slide them towards you. These drawers are handy for storing items that are not easily stacked on the shelves. Hinged door compartment To access the compartment, lift the hinged door until it reaches the guide track then slide it back into the compartment.
CARE AND MAINTENANCE Cleaning the appliance WARNING WARNING Before cleaning: Turn appliance off at the power point, then remove power cord from socket. This will make sure there is no chance of getting an electric shock. • Doors – stainless steel This stainless steel has a special advanced protective coating that eases the removal of marks such as finger prints and water spots. To keep your stainless steel appliance looking at its best, you should clean it regularly.
FOOD STORAGE TIPS When first starting-up or after a period out of use, let the appliance run at least 2 hours on the higher settings before putting food in the compartment. Energy saving tips We recommend that you follow the tips below to save energy. • Avoid keeping the door open for long periods in order to conserve energy. • Ensure the appliance is away from any sources of heat. (Direct sunlight, electric oven or cooker etc.) • Don’t set the temperature colder than necessary.
TROUBLESHOOTING If you think something may be wrong with your freezer, you can carry out some easy checks before calling for service. You may locate the problem, sparing yourself from inconvenience, saving time and money. PROBLEM SOLUTION Freezer is not operating • Check that the power cord is plugged into the power outlet properly and that the outlet is switched ‘ON’. • Check whether the “Power” funtion is on by pressing the “power” button for 1 second.
TROUBLESHOOTING When the motor seems to run more than expected Your new freezer has a large compartment to keep cool. So it is normal to frequently hear the sound of the motor. However, to keep operation to a minimum check the following: • Are doors kept open too long or too often? • Are controls set too cold? See ‘Controlling the temperature’ on pages 11. • Have large amounts of warm food just recently been stored? Summer, festive seasons and holidays usually mean a lot more work for your freezer.
NOTES NOTES 17
NOTES 18 NOTES
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: REFRIGERATION This document sets out the terms and conditions of the product warranties for Electrolux Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Appliance. 1.
For more information on all Westinghouse appliances, or for dimension and installation information, call into your retailer, phone or email our customer care team or visit our website: AUSTRALIA phone: 1300 363 640 fax: 1800 350 067 email: customercare@electrolux.com.au web: westinghouse.com.au NEW ZEALAND phone: 0800 436 245 fax: 0800 225 088 email: customercare@electrolux.co.nz web: westinghouse.co.
