WES31-1200 Heater
PAGE 1
has hot and arcing or sparking parts inside. 1-866-967-7333 21.Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended. 22. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container. 23.Always plug heaters directly into a wall outlet/receptacle.
SAVE THESE INSTRUCTIONS GROUNDING INSTRUCTIONS This heater is for use on 120 volts. the cord has a plug as shown at A in below photo. An adapter as show at C is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding plug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if another-slot grounded receptacle is available.
PAGE 5
PAGE 6
Luminous indicators Control Panel Back Reflecting panel Infrared lamp Protection grille Front Hook Remote control PAGE 9
PAGE 10
At least 100 cm PAGE 11
SWING 600 1200 Function on remote control 1: There is not ON function on remote control 2: Press TIMER+, product will run from 0.5H, 1H,2H & 4H accordingly. 3: Press TIMER-, product will run from 4H, 2H, 1H & 0.5H accordingly.
ALL SEASON INFRARED HEATER Hook to hold the remote control for convenient storage. In the event of overheating,the device is protected by a thermostat that: Disconnects the power supply of the lamp Indicates an error has occured through a beep-beep sound.The sound stops only when the thermostat reaches a normal temperature. If this happens,you need to: Unplug the device Thermal protector reset button Remove the cause of overheating Wait until the device has cooled down,before plugging it in.
Cleaning Before cleaning the unit,you must first disconnect it from the AC wall outlet. During cleaning,do not dampen the WES31-1200 All Season Infrared Heater or spray water onto it. To clean the WES31-1200 All Season Infrared Heater and the reflector,use a soft cloth. Should the surface be very dirty,dampen the cloth with warm water or with a neutral/delicate detergent before cleaning.Use a soft and dry cloth to remove the excess humidity.
PAGE 15