Clothes Dryer Model: WDV555HQWA WDV655HQWA
WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time. Welcome to Electrolux.
1. IMPORTANT SAFETY INSTRUCTIONS 1.1 Dryer Safety Failure to follow these safety instructions could damage the dryer or your clothes You may then not be covered by warranty for this damage. Only plug this appliance directly into an AC power supply, which is properly earthed and has the correct voltage. See the serial number sticker located on the bottom of the door opening for voltage information.
1.3 Cleaning The Lint Filter 1.4 Drying Guide LINT BUILD-UP IS A FIRE HAZARD Your load, when dry must not exceed the rated capacity 5.5 kg for the WDV555HQWA dryer 6.5 kg for the WDV655HQWA dryer (See page 11 for a table of average weights of laundry items) Always check your labels for the drying symbolwhich this international Care Labelling Code now uses. A clean lint filter reduces drying times, saves energy and avoids overheating. Overheating may also damage your clothes.
2. INSTALLATION INSTRUCTIONS You can choose to put your dryer : on the floor on a work bench. on a wall, upside down or upright, using the include mounting kit. on top of a front load washing machine using a stacking kit available as an optional extra (not available for all washing machine models). Mains Cable Air Inlet Duct Control Panel Door Handle Door Exhaust Grille Removable Exhaust Grille Do not install your dryer in a cupboard or small un-vented laundry unless you are using a venting kit.
Inverted Mounting Mode If machine is installed up side down follow instruction below to adjust the display for correct reading. Fast Norm Gentle Airing Dry Mode 1. Switch the machine “ON” Press and hold Dry Mode and Start/Pause buttons for 3 seconds to go into Setup Mode. display will show “SEt”. 2s Hold Dry mode and Start/Pause button 3 sec. Fast Norm Gentle Airing Dry Mode 2. Press Dry Mode button 2 times. display will show “InVE”. 2s Press Dry mode 2 times 3.
3. USE 3.1 The Control Panel 1 1 2 4 3 DISPLAY PROGRAM SELECTOR KNOB 2 Turn the Program Selector knob to choose a drying program. The table “Program Guide” shown on page 9 will help you in selecting the right program. The display shows the following information NOTES : The Program Selector knob is not a timer. Once you select a dry program, the Program Selector knob will stay at that position for the whole dry cycle.
Touch this touch pad to select the drying mode. Corresponding light for each mode is shown on display. Drying mode can only be selected during initial set up. ANTI CREASE CYCLE IN PROGRESS To prevent creases forming in the clothes after normal drying cycle has ended. The Anti crease progress indicator will start blinking during the time anti crease phase is running.
3.2 Operating Sequence Step 1 Load your dryer loosely until it is no more than TWO THIRDS FULL. Clothes must tumble freely in a dryer. Don’t crem them in. Wet clothed fluff up when dry. Program Guide Overloading will : Reduce efficiency Increase drying time Increase the risk of creasing. Do not load clothes or other articles which are dripping wet or have sand and grit on them into your dryer. Step 2 Step 3 Turn the Program Selector knob to choose drying program you want.
WARNING: Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. Checking the Load both at Step 3 Turn the Program Selector knob to “OFF” When you have finished using the dryer to turn off the power, then switch off at the power point. It is recommended to power off the appliance when not in use. Step 4 Clean Lint Filter After every load clean the lint filter to reduce drying time and avoid overheating. 4.
Due to variations in dryer load fabric texture and thickness it is possible that not all items will be dried evenly. It you experience uneven dryness on Cupboard program please use either Extra Dry or Timer Program but be mindful of the type of fabric being dried to avoid overdrying certain types of fabric. Always follow drying instructions attached to the items intended to be dried in a clothes dryer.
5. TROUBLESHOOTING & ACCESSORIES 5.1 Troubleshooting Important Check the points listed here before you call for help, and make sure that you have followed the Important safety Instructions on pages 3 and 4. To operate efficiently the clothes dryer must have an unrestricted air supply and exhoust ventilation. Problem The dryer will not start: Service calls resulting from installation where ventilation is restricted are not covered by warranty.
15 Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: ELECTROLUX DRYER (d) damage to the Appliance caused by: (i) negligence or accident; This document sets out the terms and conditions of the product warranties for Electrolux Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should there be a manufacturing defect in your Appliance.
G0020518-001-A12554103
