User manual

2. Pull the worktop behind the appliance (2).
3. Lift the worktop and move it from the front
slots (3).
4. Level of the appliance using the adjusta-
ble feet.
5. Install the appliance under the kitchen
worktop. Ensure that water hoses are not
kinked or squashed.
The appliance must be easily accessible to
the technician if a repair is necessary.
Adjusting the level of the appliance
Make sure that the appliance is level to close
and seal the door correctly. If the level of the
appliance is correct, the door does not catch
on the sides of the cabinet. If the door does
not close correctly, loosen or tighten the ad-
justable feet until the appliance is level.
Water connection
Water inlet hose
Connect the appliance to a cold water sup-
ply.
Connect the inlet hose to a water tap with an
external BSP thread spout of 3/4”.
Inlet water supply
• Cold water pressure: 800 kPa max - 50
kPa min.
• Water flow rate 10 L / minute min.
• If cold water pressure is in excess of 800
kPa, a pressure reducing valve should be
used. Check for leaks.
Caution! Always use new hoses when
you connect the appliance to the water
mains. Old hoses must not be used. The
water inlet hose must be examined at an
interval of twelve months for
deterioration and replaced if necessary.
The water pressure must be in the limits (refer
to 'Technical data'). Make sure that the local
water authority gives you the average mains
pressure in your area.
Make sure that there are no kinks in the water
inlet hose and that the water inlet hose is not
squashed or entangled.
Fit the hose nut correctly to prevent water
leaks.
Caution! Do not connect the appliance
to new pipes or pipes that have been not
used for a long time. Let the water run
for some minutes, then connect the inlet
hose.
Water drain hose
The highest point of the drain hose must be
no more than 60 cm from the floor and must
have a continuous fall to the plumbing con-
nection.
The drain hose can be lengthened using ad-
ditional lengths and connectors. These must
be purchased from Electrolux Spare Parts.
The extension length must not exceed 2 me-
tres.
The drain hose must be free of kinks and ob-
structions.
Remove the sink plug when the appliance
drains the water to prevent that the water
goes back into the appliance.
If you connect the water drain hose to a trap
spigot under the sink, remove the plastic
membrane. If you do not remove the mem-
brane, remaining food can cause a blockage
in the drain hose spigot.
16 westinghouse