User manual

If a program light is on, cancel the program
to go back to the setting mode. Refer to
'Select and start a washing program'.
USE OF THE APPLIANCE
Refer to specified instructions for each step
of the procedure.
1. Fill the rinse aid dispenser with rinse aid.
2. Load cutlery and dishes into the appli-
ance.
3. Set the correct washing program for the
type of load and soil.
4. Fill the detergent dispenser with the cor-
rect quantity of detergent.
5. Start the washing program.
USE OF RINSE AID
Caution! Only use rinse aid specified
for dishwashers.
Do not fill the rinse aid dispenser with
other products (e.g. dishwasher clean-
ing agent, liquid detergent). This can
cause damage to the appliance.
Rinse aid makes it possible to dry the
dishes without streaks and stains.
Rinse aid is automatically added during
the last rinsing phase.
Follow these steps to fill the rinse aid dis-
penser:
1. Press the release button (A) to open the
rinse aid dispenser.
2. Fill the rinse aid dispenser with rinse aid.
The mark 'max.' shows the maximum
level.
3. Remove the spilled rinse aid with an ab-
sorbent cloth to prevent too much foam
during the subsequent washing pro-
gram.
4. Close the rinse aid dispenser.
Adjusting the rinse aid dosage
Fill the rinse aid container when the indica-
tor (B) becomes clear.
The rinse aid is set at the factory at position
4.
You can set the rinse aid dosage between
position 1 (lowest dosage) and position 6
(highest dosage).
6 westinghouse