User manual

WHAT TO DO IF…
The appliance does not start or stops dur-
ing operation.
If there is a fault, first try to find a solution to
the problem yourself. Refer to following
charts. If you cannot find a solution to the
problem yourself, contact your dealer or the
Customer Care Centre.
Warning! Switch the appliance off
before you do the suggested corrective
actions.
Fault code and malfunction Possible cause and solution
• The running program light contin-
ues to flash
• The READY indicator light flashes
once
The appliance does not fill with wa-
ter
• The water tap is blocked or restricted with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The installation of the water inlet hose is not correct. The
hose can be kinked or squashed.
Make sure that the installation is correct.
• The running program light contin-
ues to flash
• The READY indicator light flashes
twice
The appliance does not drain
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The installation of the water drain hose is not correct. The
hose can be kinked or squashed.
Make sure that the installation is correct.
The program does not start • The appliance door is not closed.
Close the door.
• Mains plug is not connected.
Plug-in appliance to the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start is set.
Cancel the delay start to start the program immediately.
After the check, switch on the appliance.
The program continues from the point of in-
terruption. If the malfunction shows again,
contact your Customer Care Centre.
For other fault codes, not described in the
chart, contact your Customer Care Centre.
These data are necessary to help you
quickly and correctly:
• Model (Mod.)
• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........
The cleaning results are not satisfactory
The dishes are not clean • The selected washing program is not applicable for the type of
load and soil.
• The baskets are loaded incorrectly so that water cannot reach all
surfaces.
• Spray arms do not turn freely because of incorrect arrangement of
the load.
• The filters are dirty or not correctly installed.
• The quantity of detergent is too little or missing.
The dishes are wet and dull • No rinse aid has been used.
• The rinse aid dispenser is empty.
westinghouse 15