Installation Guide

Page 15
MEMORY FUNCTION
Allows you to set up upto 3 of your
most readily used time / temperature
combinations into memory.
EXAMPLE:
To cook the food with 80% microwave
power for 3 minutes and 20 seconds as
the second memory (Memory 2).
The steps are as follow:
a. In standby mode, press “ Favorite”
twice until the screen displays “2”.
b. Press “COOK TIME “once,then press
“3”,”2”,”0” in order.
c. Press “POWER LEVEL “once,”PL10”
display,then press “8” and “PL8”
displays.
d. Press “Favorite” to save the setting.
Buzzer sounds once then turns back
to standby mode. If you press “ START
/+ 30 sec” again, the combination will
be saved as memory 2 and operate as
programmed.
e. When you want to use memory 2 at
a later time, in standby mode, press
“Favorite” twice, (screen displays “2”),
then press “ START/+ 30 Sec. “ to
start cooking
Note: Defrosting and Auto Menu cannot
be set in memory function.
If electricy is interuppted,
programmed memory functions
will need to be re-entered.
ENGLISH/FRENCH MODE
The default language mode is English.
In standby mode, open the door and
then press “1” for 3 seconds to switch
language mode to french. Repeat to
change back to English.
CHILD LOCK FUNCTION
To Lock: In standby mode, press “ Stop/
Cancel” for 3 seconds. There
will be a long “beep” denoting
the entering into the child-lock
state and the lock indictor will
light. The screen will display the
current time or “0:00.”
To Unlock: In locked state, press “Stop/
Cancel .“Beep” will denote
that lock is released.
DOOR LOCK FUNCTION
If the unit has not been in use for over
5 minutes, it will activate the door lock
function. You cannot press” START/+ 30
Sec “ to start cooking unless you open
and close door rst.
Note: The “Kitchen Timer” function is not
affected by door lock function.
END COOKING REMINDER
When cooking is over, the unit will sound
5 “beeps” to signal the cycle is nished.
OTHER SPECIFICATIONS
1. The maximum cooking time is 99
minutes and 99 seconds.
2. When the cycle is nished, the screen
will display “End” or “Fin.” Opening
the door or pressing “Stop / Cancel”
reverts the unit to standby mode.
Text English mode French mode
End End Fin
Door Door Prte
SET UP & USE