Warranty
Table Of Contents
- Part 1 - General Safety Information
- Part 2 - Before You Start
- Part 3 - Prepare the Appliance Installation
- A. Locating the Appliance
- B. Leveling
- C. Clearances for Service Access
- D. Residential Garage and Closet Installations
- E. Exhaust Vent and Intake Pipe
- F. Carbon Monoxide Detectors
- G. Prevent Combustion Air Contamination
- H. Removing a Appliance from a Common Vent System
- I. Technical Specifications
- J. Wall-Mounting (Wall Mount Models Only)
- K. Flow Restrictor
- Part 4 - Water Piping
- Part 5 - Venting
- A. General
- B. Approved Materials for Exhaust Vent and Intake Pipe
- C. Additional Requirements for Installation in Canada
- D. Exhaust Vent and Intake Pipe Location
- E. Exhaust Vent and Intake Pipe Sizing
- F. Tightening Appliance Collar to Exhaust Vent and Intake Pipe
- G. Exhaust Vent and Intake Pipe Installation
- H. Applications
- Part 6 - Installing the Condensate Drain
- Part 7 - Connecting Electrical Service
- Part 8 - Gas Connections
- Part 9 - Controls
- Part 10 - Troubleshooting
- Part 11 - Start-Up
- Part 12 - Installation Checklist
- Part 13 - Maintenance
- Part 14 - Moving Adapters from Left to Right (Floor Models)
- Part 15 - Replacement Parts
35
whl-648 Rev. 000 Rel. 009 Date 1.4.19
Screen Installation
After connecting the intake air and exhaust vent pipes, it is required to install the included screens into the exhaust vent and intake pipe
terminations to prevent damages to the unit due to blockages. See Figure 24 for installation detail.
Figure 24 - Screen Installation - NOTE: Vent termination elbow is meant to be installed open end facing the ground. Orientation in Figure 24 is meant
to demonstrate proper Vent Screen installation ONLY.
NOTES:
A. For every 1” of overhang, the exhaust vent must be located 1” vertical below overhang (overhang means top of building structure and not
two adjacent walls [corner of building]).
B. Typical installations require 12” minimum separation between bottom of exhaust outlet and top of air intake.
C. Maintain 12” minimum clearance above highest anticipated snow level or grade (whichever is greater).
D. Minimum 12” between vents when installing multiple vents.
E. 12” minimum beyond air intake.
24.00
LP-325-OO
02/04/15
Intake
Exhaust
A
03/31/1
1
FRONT VIEW
SIDE VIEW
LP-325-PP
EXHAUST
AIR INTAKE
F
E
D
C
EXHAUST
AIR INTAKE
B
Figure 23 - Horizontal (Snorkel) Venting