Specifications

EV Inverter Operating Manual
___________________________________________________________________________
TECO – Westinghouse Motor Company 1
TABLE OF CONTENTS
Page
Introduction ……………………………………………………………………………….. 3
Section 1 Safety Precautions ………………………………………………………….. 3
1.1 Preface ………………………………………………………………….. 3
1.2 Receiving and Inspection ……………………………………………... 3
1.3 Installation and Pre-operation ………………………………………… 4
1.4 During Power ON ………………………………………………………. 4
Fig. 1 EV Pictorial Wiring Diagram ……………………………………………… 5
Section 2 Inverter Option Modules…………………………………………………… 6
Fig. 2.1 Option Card Installation and Wiring.................................. 6
Fig. 2.2 RS485 Interface (P/N SIF-485) .......………………………. 7
Fig. 2.3 RS232 Interface (P/N SIF-232) ……………………………. 7
Fig. 2.4 Copy Module (P/N SIF-MP) ……………………………….. 7
Fig. 2.5 Remote Keypad (P/N SDOP-LED-2M)............................. 8
Fig. 2.6 I/O Module (P/N SIF-IO)…………………………………….. 8
Fig. 2.7 PDA Link………………………………………………………. 8
Section 3 Control Signal Terminal Block Description…………………………… 9
Fig. 3.1 Control Terminals Designations…………………………… 9
Section 4 Input Power Terminal Block Description………………………………. 10
Fig.4.1 Power Input Terminals Designations………………………… 10
Section 5 Output Power (Motor and Brake) Terminal Block Description…….. 10
Fig. 5.1 Power Output Terminals Designations……………………. 10
Section 6 Peripheral Power Devices………………………………………………… 11
Section 7 Fuse Types and Ratings………………………………………………….. 12
Section 8 Quick Start Guide………………………………………………………….. 13
Section 9 Keypad Key Functions and Navigation………………………………… 14
Fig. 9.1 EV Keypad
9.1 Key Functions………………………………………………………….…... 14
9.2 Keypad Navigation………………………………………………………… 15
Fig. 9.2.1 Basic Keypad Control………………………………………. 15
9.3 Local / Remote Function………………………………………………….. 15
9.4 Setting Parameters F (Basic) and C (Advanced)………………………. 16
Fig.9.4.1 Set F (Basic) and C (Advanced) Parameters……………… 16
Section 10 Parameters F (Basic) and C (Advanced) ……………………………… 17
Table 10.1 F (Basic) Parameters……………………………………. 17 - 20
Table 10.2 C (Advanced) Parameters………………………………. 21 - 26
Section 11 Parameter Description (Basic) and C (Advanced) …………………. 27
Basic……………………………………………………………………… 27 - 42
Advanced………………………………………………………………… 43 - 53
Section 12 Envelope and Dimensional Tables…………………………………...... 54