Instruction manual
Table Of Contents
- Preface
- Safety Precautions
- Table of Contents
- Warnings, Cautions and Conformity
- Chapter 1 Drive Model Identification
- Chapter 2 Mounting and Wiring the Inverter
- Chapter 3 Operation using the Keypad
- Chapter 4 Function Codes / Parameters
- Chapter 5 Check Motor Rotation and Direction
- Chapter 6 Speed Reference Command Configuration
- Chapter 7 Operation Method Configuration (Run / Stop)
- Chapter 8 Motor and Application Specific Settings
- Chapter 9 Using PID Control for Constant Flow / Pressure Applications
- Chapter 10 Troubleshooting
- 10.1 Protective Functions
- 10.2 Before Proceeding with Troubleshooting
- 10.3 If Neither an Alarm Code Nor "Light Alarm" Indication Appears on the LED Monitor
- 10.4 If an Alarm Code Appears on the LED
- 10.5 If the “Light Alarm” Indication Appears on the LED Monitor
- 10.6 If an Abnormal Pattern Appears on the LED Monitor except Alarm Codes and "Light Alarm" Indication
- 10.7 If the Inverter is Running on Single-Phase Power
- Chapter 11 Specifications
3-14
Output frequency (before slip compensation)
Output frequency (after slip compensation)
Output current
Output voltage
Calculated torque
Reference frequency
Running status (See Table 3.7.)
Motor speed
Load shaft speed
Line speed
Constant peripheral speed control monitor
PID command value
PID feedback amount
PID output value
Torque limit value A
Torque limit value B
Reserved.
Current position pulse
Stop position target pulse
Position deviation pulse
Positioning control status
Motor temperature
Ratio setting
Magnetic flux command value
Deviation in SY synchronous operation
Current position pulse
Stop position target pulse
Position deviation pulse
Reserved.
: End of page
Common operation items
To access the target data, switch to the desired page using the and keys.
: This page continues to the next page.
: This page is continued from the previous page and continues to the next page.
: This page is continued from the previous page.
Figure 3.12 Screen Transition for "Drive Monitoring"
(3) Press key to establish the desired menu and proceed to a list of monitoring items.
1/8: Page # in operation guide, means that this page continues to the next page.
/
/
/
/
/
/
(4) Use and keys to select the page on which the desired monitor item is shown.
((5) To go back to the menu screen, press key.)
/