Instruction manual

2-4
2.3 Wiring
Follow the procedure below. (In the following description, the inverter has already been installed.)
2.3.1 Removing and mounting the front cover and the wiring guide
(1) For inverters of 40 HP or below
First loosen the front cover fixing screw, slide the cover downward holding both sides, tilt it forward, and then pull it
upward, as shown below.
While pressing the wiring guide upward, pull it out and forward.
After carrying out wiring (see Sections 2.3.2 through 2.3.6), put the wiring guide and the front cover back into place
in the reverse order of removal.
Figure 2.4 Removing the Front Cover and the Wiring Guide (e.g EQ7-4020-C)
(2) For inverters of 50 to 1000 HP
Loosen the four front cover fixing screws, hold the cover with both hands, slide it upward slightly, and pull it forward,
as shown below.
After carrying out wiring (see Sections 2.3.2 through 2.3.6), align the screw holes provided in the front cover with the
screws on the inverter case, and then put the front cover back into place in the reverse order of removal.
To expose the control printed circuit board (control PCB), open the keypad enclosure.
Tightening torque: 15.9 lb-in (1.8 N

m) (M4)
31.0 lb-in (3.5 N

m) (M5)
Figure 2.5 Removing the Front Cover (e.g. EQ7-4050-C)