Instruction manual
Table Of Contents
- Preface
- Safety Precautions
- Table of Contents
- Warnings, Cautions and Conformity
- Chapter 1 Drive Model Identification
- Chapter 2 Mounting and Wiring the Inverter
- Chapter 3 Operation using the Keypad
- Chapter 4 Function Codes / Parameters
- Chapter 5 Check Motor Rotation and Direction
- Chapter 6 Speed Reference Command Configuration
- Chapter 7 Operation Method Configuration (Run / Stop)
- Chapter 8 Motor and Application Specific Settings
- Chapter 9 Using PID Control for Constant Flow / Pressure Applications
- Chapter 10 Troubleshooting
- 10.1 Protective Functions
- 10.2 Before Proceeding with Troubleshooting
- 10.3 If Neither an Alarm Code Nor "Light Alarm" Indication Appears on the LED Monitor
- 10.4 If an Alarm Code Appears on the LED
- 10.5 If the “Light Alarm” Indication Appears on the LED Monitor
- 10.6 If an Abnormal Pattern Appears on the LED Monitor except Alarm Codes and "Light Alarm" Indication
- 10.7 If the Inverter is Running on Single-Phase Power
- Chapter 11 Specifications
6-2
6.2 Reference from External Analog Signal (0 - 10V / 0 – 20mA / 4 - 20mA)
Analog Reference: 0 – 10 V (Setting F01 = 1)
G
Connect shield to
ground terminal
0 – 10 V
+
-
Analog Input T12Common/0V, T11
Control Terminals /
User Terminals
Analog Reference: Potentiometer / Speed Pot (Setting F01 = 1):
G
Connect shield to
ground terminal
Potentiometer
1 ~ 5K Ohm
+10VDC, T13
Common/0V, T11
Analog Input T12
Control Terminals /
User Terminals