Instruction manual
Table Of Contents
- Preface
- Safety Precautions
- Table of Contents
- Warnings, Cautions and Conformity
- Chapter 1 Drive Model Identification
- Chapter 2 Mounting and Wiring the Inverter
- Chapter 3 Operation using the Keypad
- Chapter 4 Function Codes / Parameters
- Chapter 5 Check Motor Rotation and Direction
- Chapter 6 Speed Reference Command Configuration
- Chapter 7 Operation Method Configuration (Run / Stop)
- Chapter 8 Motor and Application Specific Settings
- Chapter 9 Using PID Control for Constant Flow / Pressure Applications
- Chapter 10 Troubleshooting
- 10.1 Protective Functions
- 10.2 Before Proceeding with Troubleshooting
- 10.3 If Neither an Alarm Code Nor "Light Alarm" Indication Appears on the LED Monitor
- 10.4 If an Alarm Code Appears on the LED
- 10.5 If the “Light Alarm” Indication Appears on the LED Monitor
- 10.6 If an Abnormal Pattern Appears on the LED Monitor except Alarm Codes and "Light Alarm" Indication
- 10.7 If the Inverter is Running on Single-Phase Power
- Chapter 11 Specifications
4-100
E46
LCD Monitor (Language selection)
E46 specifies the language to display on the keypad (TP-G1W-J1) as follows:
Data for E46
Language
0
Japanese
1
English
2
German
3
French
4
Spanish
5
Italian
E47
LCD Monitor (Contrast control)
E47 adjusts the contrast of the LCD monitor on the keypad as follows:
Data for E47
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10
Contrast
Low High
E48
LED Monitor (Speed monitor item) (Refer to E43.) see page 4-98
E50
Coefficient for Speed Indication
E50 specifies the coefficient that is used when the load shaft speed or line speed is displayed on the LED monitor.
(Refer to the description of E43.)
Load shaft speed (r/min) = (E50: Coefficient for speed indication) (Output frequency Hz)
Line speed (m/min) = (E50: Coefficient for speed indication) (Output frequency Hz)
- Data setting range: 0.01 to 200.00
E51
Display Coefficient for Input Watt-hour Data
E51 specifies a display coefficient (multiplication factor) for displaying the input watt-hour data (5_10 ) in a part of
maintenance information on the keypad.
Input watt-hour data = Display coefficient (E51 data) Input watt-hour (kWh)
- Data setting range: 0.000 (cancel/reset); 0.001 to 9999
Setting E51 data to 0.000 clears the input watt-hour and its data to "0." After clearing, be sure to restore
E51 data to the previous value; otherwise, input watt-hour data will not be accumulated.