User Manual

Page 36
Overview:
Lock ID is used to distinguish between locks for sites with multiple locks installed. By
default, all locks are set as 0001.
Note: The Lock ID of the RTS is critical when using the MS1 Management Software (for
programming and audit trail). The Lock ID in the MS1 MUST correspond with the Lock
ID in the MS1 software. If the Lock IDs do not correspond, the lock records may be
corrupted.
3) “SAVED!” indicates Lock ID
setting was saved. This will display
momentarily and then the setup
menu will be shown.
1) In the Lock Setup menu, scroll
down to Option 4 “Lock ID”
Press M.
2) Use the Up/Down arrows to
scroll to the desired lock ID.
Press M to save setting.