User Manual

Page 23
If the scan attempt was unsuccessful, “Failed” will display on the LCD and 1N will not
change to 1Y. Repeat the steps above to try again.
Note: The same finger can be used for fingers 2 and 3. This is recommended for Users
with poor quality fingerprints. Usually different fingers will be used for fingers 1, 2 and 3.
If unsuccessful, “Failed” will display on the LCD and 2N will not change to 2Y. Repeat
the steps above to try again.
7) If finger 1 was successfully
enrolled, a single short beep will
be heard, the LCD will display
“Success,” and “1N” will change to
“1Y.”
8) Rest finger on sensor. Press
the Up Arrow to highlight “2N.”
Press M.
2N changed to 2Y indicates a
successful scan.
“Capturing…” will be shown while
the FP is being scanned.