User Manual

Page 18
Note (RTS-Z and RTS_PZ only): When a Hard Reset is complete, the zwave node ID
is initialized to zero and the device can’t be controlled by zwave. In order to control the
device again, the controller needs to include the device on the zwave network. Please
use this procedure only when the network primary controller is missing or otherwise
inoperable.
Section 6: Finger Print and PIN Management
Overview for RTS-P, RTS-PZ, RTS, RTS-Z:
User IDs 1-3 (and their associated fingerprints) are “Administrators.” They have
complete access to program the RTS and to unlock the door at any time.
User IDs 4-7 (and their associated fingerprints) are “Managers.” They have limited
access to program the RTS. Managers can delete User IDs, edit the Timed TUM menu,
and unlock the door at any time
User IDs 8-999 (and their associated fingerprints) are “General Users.” They have
access to unlock the door at times set up by one of the Administrators. General Users
and have no programming rights on the RTS.
“Initializing” is shown while the
lock is being reset.
“Initializing Done!” is shown
when the reset is complete.
2) “Reset to factory defaults?” will
display on the LCD.
Press M to reset.
Press E to exit without resetting.