User Manual

Page 14
3.4 Installing the Inside Unit
Remove Bag “D” from the box.
1) Insert the Spindle though the
fixing plate and into the inside
section of the lock’s spindle hole.
2) Place the rubber gasket onto
the inside section of the lock.
3) Insert the spindle spring into
the lock handle hole. This is a
very important step.
5) Plug the cable into the lock.
Note: Be sure that the connector is
fully seated. Connect or hardwire
the other wires where applicable.
(See Section 10)
4) Feed the cable from the inside
lock through the opening in the
bottom side of the fixing plate.
Note: There are 6 wires for direct
power, normally open, and RS485
devices. See Section 10 for
specifics. These can be removed
if they are not used or placed
inside the door for future use.