User Guide

34
1. Do not show Zwave Setup Guide at startup – Normally, the Zwave Setup Guide is shown each
time the MS1 is launched. See Page 2. Check this box to disable the Guide. If you had
previously inhibited the display of the Zwave Setup Guide at startup, you can re-enable it here
but unchecking this box.
2. Low Battery Alarm – If this box is checked, the RTS-Z will sound an alarm when a battery for any
associated Z-wave device gets low. This is the default setting. Uncheck this box to disable the
alarm.
3. Low Battery Limit – This sets the threshold for the low battery alarm. Default is 15%.
4. Using Polling Cycle – TBD
5. Disconnect Room Alarm – TBD
6. Polling Cycle – TBD
7. Failed Count – TBD
8. Retry Count – TBD
After making the desired changes, click the Apply button to save the changes.
Add User
This button allows the addition of users to the MS1 software. Note that this does not add users to locks.
The following items may be entered on this page:
1. Login Name
2. Verification Mode – Verify by Password, Fingerprint, or both.
3. Role – Administrator or User. Administrators can access all fields shown on the Settings form
displayed above. Persons designated as User can access all functions of the MS1 except being
limited to only making Settings tab changes to the functions General and Modify User.
4. Password – This may be up to 26 characters and may be letters or numbers.
5. Confirm Password – Enter the same password as above.
6. Regular FP – Requires a USB fingerprint scanner. Place finger on scanner and hit Enroll.
7. Backup FP – Requires a USB fingerprint scanner. Place finger on scanner and hit Enroll.