User Guide

28
These icons are used to either ‘Refresh’ (non-volatile) or ‘Reset’ (volatile) Z-Wave settings.
These icons send a ‘Lock’, ‘Unlock’, or ‘Get Lock State’ command to the selected Z-Wave lock.
These icons send ‘Sync Settings’ (send Lock settings), ‘Sync Users’ (send User FP and PIN info), and ‘Get Records’
(request Audit trail) to the selected Z-Wave lock.
This icon is used to push firmware updates ‘Over The Air’ to the selected Z-Wave lock.
These icons ‘Auto Routing’ and ‘Disable Node’ are used to either establish the most efficient path from the MS1 to the
selected lock using available network nodes or to disable the previously established node path.
To initially build the association between the MS1 controller application and a lock, you may start with an idle
template by first selecting the ‘Reset’ icon. Following this action, both the Lock Group and Lock screens appear as
shown below: