Specifications
Table Of Contents
- PowerBook 190/5300 Series
- Basics
- Specifications
- Troubleshooting
- Take Apart
- Introduction
- Before You Begin
- Battery
- Floppy Drive
- I/O Door
- Front Feet
- Rear Feet
- Keyboard
- RAM Card
- Clutch Covers
- PC Switch Board (PCMCIA)
- Display Assembly
- Palm Rest
- Sleep Actuator
- Trackpad
- Hard Drive
- Power Supply Board (5300 Series Only)
- Backup Battery
- Heat Sink
- Video Board (Optional on 190 Series)
- Logic Board
- CPU Stiffener
- Infrared Board (Optional on 190 Series)
- Media Bay LED
- PC Card Door (PCMCIA)
- Video Expansion Cover (Optional on 190 Series)
- Reset Actuator
- Sound-In Cover (190 Series Only)
- Media Bay Release Mechanism
- Display Housing
- Inverter Board
- Display
- Microphone
- Speaker
- Clutches
- Floppy Drive Mechanism
- Upgrades
- Additional Procedures
- Exploded View
Basics PC Card Handling - 18
PC Card Handling
Two PC Card slots (formerly PCMCIA) are a feature in the
PowerBook 190/5300 Series. The two slots accept a variety
of third-party PC Cards.
There are three types of PC Cards: Type I (3 mm), Type II
(5 mm), and Type III (10.5 mm). Type I and Type II cards
fit in either the upper or lower slot of the PC Card unit.
Type III cards fit in the lower slot and take up both slots.
The following are guidelines for properly handling the PC
Card:
• Use only cards that are compatible with the PC Card unit.
Refer to the compatibility information that came with the
card. If you cannot find the compatibility information,
call the card vendor.