Specifications
Table Of Contents
- PowerBook 190/5300 Series
- Basics
- Specifications
- Troubleshooting
- Take Apart
- Introduction
- Before You Begin
- Battery
- Floppy Drive
- I/O Door
- Front Feet
- Rear Feet
- Keyboard
- RAM Card
- Clutch Covers
- PC Switch Board (PCMCIA)
- Display Assembly
- Palm Rest
- Sleep Actuator
- Trackpad
- Hard Drive
- Power Supply Board (5300 Series Only)
- Backup Battery
- Heat Sink
- Video Board (Optional on 190 Series)
- Logic Board
- CPU Stiffener
- Infrared Board (Optional on 190 Series)
- Media Bay LED
- PC Card Door (PCMCIA)
- Video Expansion Cover (Optional on 190 Series)
- Reset Actuator
- Sound-In Cover (190 Series Only)
- Media Bay Release Mechanism
- Display Housing
- Inverter Board
- Display
- Microphone
- Speaker
- Clutches
- Floppy Drive Mechanism
- Upgrades
- Additional Procedures
- Exploded View
Take Apart Hard Drive - 42
3 Rotate the right side of
the hard drive bracket
over the left so that the
bracket is sitting upside
down to the left of the
computer.
4 Disconnect the hard
drive cable from the
logic board by carefully
pulling straight up on
hardened plastic back of
the cable connector.
5 Remove the 4 screws
holding the drive in the
bracket.
Hard Drive Cable Connector
Heat Sink Leaf Spring
Screw
Screw
Screw
Screw