Specifications
Table Of Contents
- PowerBook 190/5300 Series
- Basics
- Specifications
- Troubleshooting
- Take Apart
- Introduction
- Before You Begin
- Battery
- Floppy Drive
- I/O Door
- Front Feet
- Rear Feet
- Keyboard
- RAM Card
- Clutch Covers
- PC Switch Board (PCMCIA)
- Display Assembly
- Palm Rest
- Sleep Actuator
- Trackpad
- Hard Drive
- Power Supply Board (5300 Series Only)
- Backup Battery
- Heat Sink
- Video Board (Optional on 190 Series)
- Logic Board
- CPU Stiffener
- Infrared Board (Optional on 190 Series)
- Media Bay LED
- PC Card Door (PCMCIA)
- Video Expansion Cover (Optional on 190 Series)
- Reset Actuator
- Sound-In Cover (190 Series Only)
- Media Bay Release Mechanism
- Display Housing
- Inverter Board
- Display
- Microphone
- Speaker
- Clutches
- Floppy Drive Mechanism
- Upgrades
- Additional Procedures
- Exploded View

Take Apart Palm Rest - 32
1 Slowly pull the palm
rest toward you (to
unlatch it from the
bottom case) and then
rotate the front of the
palm rest over the back
until the palm rest is
laying upside down in the
area the keyboard
occupied.
Caution:
Make certain that
you do not pull the trackpad
cable out of the connector as
you rotate the palm rest.
2 Release the trackpad
cable by lifting up the
connector ears.
Palm Rest
Tab
Tab
Trackpad
Cable Connector