Specifications
Table Of Contents
- PowerBook 190/5300 Series
- Basics
- Specifications
- Troubleshooting
- Take Apart
- Introduction
- Before You Begin
- Battery
- Floppy Drive
- I/O Door
- Front Feet
- Rear Feet
- Keyboard
- RAM Card
- Clutch Covers
- PC Switch Board (PCMCIA)
- Display Assembly
- Palm Rest
- Sleep Actuator
- Trackpad
- Hard Drive
- Power Supply Board (5300 Series Only)
- Backup Battery
- Heat Sink
- Video Board (Optional on 190 Series)
- Logic Board
- CPU Stiffener
- Infrared Board (Optional on 190 Series)
- Media Bay LED
- PC Card Door (PCMCIA)
- Video Expansion Cover (Optional on 190 Series)
- Reset Actuator
- Sound-In Cover (190 Series Only)
- Media Bay Release Mechanism
- Display Housing
- Inverter Board
- Display
- Microphone
- Speaker
- Clutches
- Floppy Drive Mechanism
- Upgrades
- Additional Procedures
- Exploded View
Take Apart Display Assembly - 30
2 Tilt the display back
170 degrees from the
keyboard and remove the
2 screws holding the
metal clutches to the
CPU stiffener.
Replacement Note:
Perform
this test to confirm you
installed the display assem-
bly correctly: Try to insert
a 3.5" diskette between the
closed assembly and the top
case. If you can, this
indicates the clutch screws
are undertightened. Remove
the display assembly and
loosen the screws.
Clutch
Clutch
Screw
Screw