Installation

1
4 westinghouse.com.au
INSTALLATION (CONTINUED)
Rotate slide-bar to lower alignment, mark a line
on cupboard door (Figure 16). Figure 16
.5
Figure 16
Remove slide-bar and draw line to indicate
central alignment (Figure 17).
.6
Figure 17
Replace slide-bar and align to centre line
marked in previous operation (Figure 18).
.7
Figure 18
Secure slide-bar by driving a cupboard screw
into the centre of the inner slot Fig 19. Gently
test closing the door.
.8
Figure 19
If the action is smooth and the slider does not
move in relation to the cupboard door, drive
another cupboard screw into the end slot Fig 20.
.9
Figure 20