Installation

7
INSTALLATION
Preparation
1. Unpack refrigerator, and remove all packaging.
2. Lay the refrigerator down on its back on a piece of
soft packing material. Use caution and two people
while laying the appliance down.
3. Place adjustable rollers in the fully retracted position
by screwing height adjusting screw fully anti-
clockwise (Figure 2). Do not remove the adjusting
nut completely.
4. Attach rear rollers.
Figure 2
Rear rollers
Plastic roller nut
INSTALLATION OF 120˚ HINGE
Please follow the instructions below to install the
120º hinge.
120º hinge
mounting plate
Attach mounting plate with 120º hinge and tighten
the screw.
120º hinge
screw
mounting plate
Use self tapping wood screws P No. A04121101 provided
to attach the hinge to the cupboard door.
screws
Use screws attached to mounting plate to attach the hinge
to the cabinet.
cabinet
37mm
cupboard door
This dimension is typically 37mm
(from centre line of mounting plate
to the cupboard cabinet edge)
Plastic roller nut