Full Product Manual

English | 19
MAINTENANCE
WARNING
Accidental start-up. Disconnect
the spark plug boot (see gure 17) from the spark
plug when performing maintenance on the generator.
WARNING
Replace damaged or worn items
with recommended or equivalent replacement parts.
Using an incorrect or incompatible part might create a
hazard that could result in serious personal injury.
WARNING
Allow hot components to cool for
30 minutes before performing any maintenance pro-
cedure.
WARNING
Avoid skin contact with engine oil
or gasoline. Wear protective clothing and equipment.
Wash all exposed skin with soap and water. Prolonged
skin contact with gasoline or engine oil may cause se-
vere skin irritation and other adverse reactions.
NOTICE
Check the physical condition of the
product prior to each use. Look for loose bolts, uid
leaks, and other signs of wear. Replace all damaged
items. For replacement parts or assistance, contact
our customer service team.
To prolong the life of this product, follow the care and mainte-
nance instructions in this section. Contact customer service
before servicing any recall or warranty parts.
CLEANING THE GENERATOR
Do not store or operate your generator in dirty, dusty, or
corrosive environments. Do not allow foreign materials and
debris to clog the vents on the unit.
NEVER clean the generator with a garden hose. Water can
damage the generator’s fuel system and electrical compo-
nents. If the unit needs to be cleaned, use a soft brush and
damp cloth to clean the exterior and use low pressure air
(no greater than 25 psi) to clean the vents.
Never use gasoline as a cleaning agent.
CLEANING/REPLACING THE AIR FILTER
See Figure 14.
Keep air lter clean. A dirty air lter can cause poor perfor-
mance and decrease the service life of the product. NEVER
operatethegeneratorwithoutanairlterinplace.
l Turn the generator off and allow the engine to cool for
30minutes.
l Loosen screws and remove the engine service cover.
l Remove the screw and air lter cover.
l Remove the air lter from the air cleaner housing and
place it in a suitable cleaning container. Replace the air
lterifdamaged.
NOTE: The air lter may be covered in oil. Use an appro-
priate container.
l Wash the air lter by submerging the lter in a solution
of household detergent and warm water. Slowly squeeze
the lter to thoroughly clean.
NOTICE
DO NOT twist or tear the air lter during
cleaning or drying. Only apply slow but rm squeezing
action.
l Rinse the air lter by submerging it in fresh water and
applying a slow squeezing action. Allow the lter to dry
thoroughly.
NOTICE
Do not pollute. Follow the guidelines
of the EPA or other governmental agencies for proper
disposal of hazardous materials. Consult local author-
ities or reclamation facility.
l Dip the air lter in clean engine oil then squeeze out all
excess oil. The engine will smoke when started if too
much oil is left in the lter.
l Install the air lter in the air cleaner housing and reinstall
the air lter cover.
l Install the engine service cover and turn the lock knob to
the locked position to secure.
A - Air Filter Cover
B - Air Filter
C - Screw
C
B
A
FIG. 14