Service manual

5-12
CHECKING THE MOTOR
To check voltages* at the motor for crushed
or cubed ice operation:
1. Open the freezer door and remove the ice
bucket from the door.
2. Tape the door switch closed.
NOTE: When you are instructed to make a
reading at the motor connector, press the tips
of the red and black test leads into the indi-
cated harness connector slots so they touch
the bare metal wire connectors. Reach around
the front of the door and press the ice dispenser
lever to activate the dispenser switch.
* Voltage readings may vary, depending on the supply
voltage, and the type of test equipment being used.
Press The Ice
Dispenser Lever
Door Switch
Taped Closed
Pin 1
Press Tips Into
Connector Slots
Against Bare Wire
Terminals To Check
Voltages
Motor Harness
Connector
Test Leads
Electrical Shock Hazard
Voltage is present during these tests.
WARNING