USER MANUAL Gas Built-in Cooking Appliances COOKING GOR474, GOR476, GGR475, GXR650 1 ACCESSORIES
congratulations Congratulations and thank you for choosing our oven. We are sure you will find it a pleasure to use. Before you use the oven, we recommend that you read through the relevant sections of this manual, which provides a description of your appliance and its functions. To avoid the risks that are always present when you use an appliance, it is important that the appliance is installed correctly and that you read the safety instructions carefully to avoid misuse and hazards.
GOR474 BEFORE OPERATING YOUR APPLIANCE FOR THE FIRST TIME Oven indicator light Function selector SETTING THE TIME If you have purchased a model fitted with an electronic clock, you must set the time of day before you can operate your appliance. Oven/Grill temperature selector 2 hour ‘Auto-off’ timer • I nsert the twin pegged side into the rear access holes provided. See diagram. • Then locate the front peg into the front access hole and push in firmly.
BEFORE OPERATING YOUR APPLIANCE FOR THE FIRST TIME 2. Shelves and trays The shelves are designed so that they have maximum travel but cannot be accidentally pulled right out. The trays are designed the same way and fit straight into the side racks. • Locate the rear edge of the shelf/tray in between 2 guide rails of the side rack - see diagram. Ensure the same rail positions on both sides of the oven are being engaged. • With the front edge raised, begin to slide the shelf into the oven.
using your OVEN cooking with your timer Cooling/Venting fan Your built-in appliance is fitted with a cooling fan. This prevents your kitchen cabinet from overheating and reduces the condensation inside the oven. It will operate whenever you are using your oven or grill and will blow warm air across the top of the oven or grill door. NOTE: If the oven is still hot from cooking, the cooling fan will keep running to cool the oven down and will switch off automatically when cool.
Operating the electronic clock (CONT.) COOKING GUIDE COOKING GUIDE Setting the delayed start cooking time 1. Program the “cook time“ and “end time“ as described in the relevant sections. Once both the “cook time“ and “end time“ have been set, the “cook time“ and “end time” indicators will stop flashing and the current time of day will be displayed. • Select the correct shelf location for food being cooked. • Make sure dishes will fit into the oven before you switch it on.
COOKING GUIDE GRILLING GUIDE GRILLING GUIDE Roasting Meat 1. Place the meat in the oven and set the temperature between 180°C and 200°C. (It is recommended to wrap your meats in an oven roasting bag or foil to prevent fats and oils from splattering, making it easier to clean your oven.) 2. Use the grill / oven dish and smokeless grill insert. Place the meat on the insert. 3. Do not pierce the meat, as this will allow juices to escape. 4.
dealing with cooking PROBLEMS (see also p.
Removing the side racks (shelf supports) – grill in oven and separate grill models • Grasp the shelf supports at the front. • Pull them firmly inwards. • To install the side racks, see page 5. • S lowly close the oven door until it is stops against the ‘stirrups’ (about 45°). Removing oven door top trim • Take hold of the grid embossed sections of the door trim at each end and press inwards to release the clips. Remove the door trim by pulling it towards you.
Re-assembling the door glass panels • Insert the smaller clear glass panel (when fitted) first from above and at an angle to the profile of the door. Re-assembling the top door trim • Take hold of the top door trim at each side and position it to the inside edge of the glass. • Push the trim down with its top edge over glass panel until the clip snaps in on each side of the trim.
MAINTAINING YOUR APPLIANCE GET TO KNOW YOUR OVEN ELECTRONIC BURNER CONTROL Releasing the grill element – grill in oven and separate grill models We have designed the upper element with a hanger clip to help you reach your cavity roof for cleaning. To remove grill, push sides of hanger clip in the direction of arrows until one hanger clip can easily be removed from retaining hole. To replace, reverse the process.
SOLVING PROBLEMS Faults If there is a problem with the oven and/or grill, please: • Check the points listed below before calling for service. It may be possible to avoid a call by fixing the problem yourself – and so continue cooking. • For cooking problems refer to page 14. INSTALLING YOUR APPLIANCE PROBLEM POSSIBLE CAUSE Oven or grill not working - Time of day not set. - Power not turned on. - Gas supply turned off or LPG bottle empty. - Controls are incorrectly set.
GAS INSTALLATION INFORMATION GAS INSTALLATION INFORMATION Gas Connection Before commencing installation, check to ensure the type of gas to which the appliance is intended to be connected matches the gas type given on the appliance data plate. Check the data plate (located behind the oven door) to determine gas type. A gas type label is located on the back panel near the gas inlet. A 1700mm long flexible hose is supplied in the pack for installation purposes.
GAS INSTALLATION INFORMATION GAS INSTALLATION INFORMATION Underbench Ovens Your underbench oven looks best when the control panel is directly under the benchtop. An upper infill panel may have to be added if the cooktop placed above the benchtop is too deep. Refer to cooktop installation instructions for required clearance between cooktop and oven. Separate grill underbench ovens GAS TYPE A B C Flush fit 600 731 581min Proud fit 565 723 560min D upper infill if required 1.
GAS INSTALLATION INFORMATION Separate grill wall oven 561 A B mounting holes C Use 15mm long black installation screws supplied 650 min 596 *20 553 carry handle 8mm min clearance 15 D 888 1.7m flexible gas hose (supplied unfitted) E 1.
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: BUILT-IN OVEN, COOKTOP AND FREESTANDING COOKER This document sets out the terms and conditions of the product warranties for Electrolux Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Appliance. 1.
For more information on all Westinghouse appliances, or for dimension and installation information, call into your retailer, phone or email our customer care team or visit our website: AUSTRALIA phone: 1300 363 640 fax: 1800 350 067 email: customercare@electrolux.com.au web: www.westinghouse.com.au NEW ZEALAND phone: 09 573 2384 fax: 0800 363 600 email: customercare@electrolux.co.nz web: www.westinghouse.co.
