User manual
WARNING
As stated in the local municipal building codes and other
relevant statutory regulations.
• Refer to data plate for rating information and circuit
diagram. The data plate is positioned behind the bottom
of the oven door. The circuit diagram is positioned on the
top panel of the appliance.
WARNING
• Do not lift the appliance by the door handles.
• Prepare the cupboard opening to match your appliance
measurements. (See diagrams).
• Slide appliance into the cupboard, ensuring that the
supply cable (where fitted) does not kink.
• To prevent tipping, use the screws supplied to secure your
oven into the cupboard. Use just 2 screws for underbench
and separate grill underbench ovens, and 4 screws for
separate grill wallovens. Remove the bottom door in
separate grill wallovens to provide access to the bottom
2 screwing points (see illustrations on page 21).
• For appliances fitted with a flexible supply cord, if
the cord is damaged, it must be replaced by the
manufacturer or its service agent or similarly qualified
person in order to avoid a hazard. The plug must be
accessible after installation.
• Where the appliance is built into a cabinet, the
cabinet material must be capable of withstanding 70°C.
Installation into low temperature tolerant cabinetry (e.g.
vinyl coated) may result in deterioration of the low
temperature coating by discolouring or bubbling.
• If the appliance is installed adjacent to vinyl-wrapped
surfaces, use an installation kit available from the vinyl-
wrap supplier.
• Electrolux Home Products cannot accept responsibility
for damage caused by installation into low temperature
tolerant cabinets.
• After installation, test and ensure that the appliance
operates correctly before handing it over to the
customer.
It is recommended that this product is not installed in an
unvented living space, particularly if that space incorporates
sleeping quarters.
CAUTION
This appliance is only suitable for connection to fixed
consumer piping where the fault pressure is limited to 14kPa
or less. Refer clause 4.6.1 of A.S. 5601.
Cabinet Construction for your appliance
For the best integration within a kitchen, install this appliance
in a standard 600mm wide cupboard that gives a flush fit
with the surrounding cupboard fronts (figure A).
A recess of 20 mm is ideal. It can also be installed using a
proud fit with the surrounding cupboard (figure B).
NOTE: Your appliance must be mounted on a flat surface
for the full width and depth of the product.
Figure A - Flush fit (top view)
Figure B - Proud fit (top view)
Cupboard front
Infill panel
Cleat
Cupboard
door
Cupboard
door
20mm
WMAN_541_Jun10.indd 19 4/6/10 10:18:33 AM