User manual

CONNECTING TO SERVICES AND COMMISSIONING

This appliance must be installed by an authorised person, according to all codes and

regulations of:

• Electrical supply authorities.

• Building regulations

• Local government and council authorities.

• AS5601/AG601 (particular attention to 5.12.1 and figure 5.1 on page 90, 5.12.1.7).

• AS/NZS 3000 (particular attention to clause 4.3.11 and clause 3.9).

Hard wiring detail

1. Remove terminal cover plate from rear

panel of appliance.

2. Fit wires through hole in cover plate

and make connections to terminals.

3. Engage wires into plastic clip. Secure

plastic clip with two long silver screws

(supplied in separate bag).

4. Replace cover plate onto rear panel.

Plastic clip

securing points.

Plastic clips

Installing the gas cooker

Gas connection

Read these points before connecting to the gas supply:

• Slide cooker into final position checking that anti-tilt bracket is engaged and that

wiring loops and gas supply are free from jamming and obstacles.

• Fit the supplied pressure regulator for Natural Gas or supplied test point union for LPG

appliances using the supplied sealing washer. Ensure the arrow is pointing towards

appliance and that the pressure test point is accessible.

• Make the gas connection to the inlet of the regulator or test point adaptor using a

fitting to suit

”BSP parallel internal thread found on these fittings. Flexible

connections are not permitted with this appliance.

Kick-panel

Kick-panel Bracket

NG Regulator

Sealing Washer

SIMPRD 342-1-529 30/1/08 8:51 AM Page 28