User manual

INSTALLING THE APPLIANCE

Wiring requirements

The cooker MUST be installed in compliance with

• wiring connections in AS/NZS 3000 Wiring Rules

• local regulations, municipal building codes and other statutory regulations

• For New Zealand Only: The cooking range must be connected to the supply by a supply cord

fitted with the appropriately rated plug that is compatible with the

socket-outlet fitted to the final sub-circuit in the fixed wiring that is

intended to supply this cooking range.

Data plate • gives information about rating

• is located behind the bottom of the oven door

Circuit diagram • is located on the back panel of the appliance

• A functional switch MUST be provided near the appliance in an accessible position (AS/NZS

3000 - Clause 4.3.11).

• Wiring MUST be protected against mechanical failure (AS/NZS 3000 - Clause 3.9).

• The cooker requires a means of all pole disconnection incorporated into the fixed wiring.

This MUST have a disconnection gap of 3mm.

• The cooker MUST be properly earthed.

Note: When connections are made to a multi-phase 230/240V supply, the bridge piece MUST

be removed from between the active connections.

IMPORTANT: Before you cook in your new oven it is important that the protective oils used in

the manufacture of the product be removed.

• Make sure that the room is well ventilated (to allow smoke to escape).

• Run the grill on high for 30 minutes without grill dish.

• Then run the oven on 220°C for 1 hour.

SIMPRD 342-1-529 30/1/08 8:51 AM Page 27