User manual

19
11
INSTALLING THE APPLIANCE
25
INSTALLING THE APPLIANCE
m600 m
600mm
mminimu
0m(
M7
2
mNO)
anti-tilt bracket
600mm
m( )
9
00m NOM
Cabinet requirements
This appliance has been designed to ‘slot-in’ to a 600mm wide gap built-in standard
kitchen cabinets. As such the appliance can be installed matching the height and depth of
benches and behind the kick rail of the cabinets. This allows the cooker to integrate well
into contemporary kitchens. The cooker may also be installed at the end of a line of
benches or with a free space on either side.
• This appliance is not supplied with a splashback.
• Ensure that all vertical surfaces (rear and sides) are non-combustible surfaces (eg
ceramic tiles, sheet metal or toughened glass).
• Refer to section 5.12.1.1 of AS5601 in Australia or section 14.1.2 of NZS5261 in New
Zealand for overhead clearances.
Warning: This appliance has been tested and approved to the relevant Australian
Standards. It is designed to cook food, it will get hot. Cabinet materials must
be capable of withstanding 85°C. Installation into lower temperature tolerant
cabinetry (eg vinyl coated) may result in deterioration of the low temperature
coating by discolour or bubbling.
Electrolux Home Products cannot accept responsibility for damage caused by installation
into low temperature tolerant cabinets.
Recommended cabinet design
Installation sequence
1 Check that the required services are correctly positioned (see electrical and gas services
requirements section and cabinet requirements section).
2 Ensure that cabinetry has correct details (see cabinet requirements section).
3 Unpack the cooker.
4 Remove the foam pack containing accessories.
5 Remove the internal pack from the oven and position shelf supports and grill trays
(see page 4).
6 On gas cookers position gas burners and trivets (see page 19).
SIMPRD 342-1-529 30/1/08 8:51 AM Page 25