Instruction manual

15
Chapter 2 Programming instructions & Parameter list
2.1 Operation Instruction of the keypad
*1: Display flashes with set frequency in stop mode, but it is solid in run mode.
*2: The frequency can be set during both stop and run modes.
 Remote/Local change function
• Local mode
Run command via RUN/STOP key on the keypad
Frequency command
When C41=000: only UP/DOWN key on the keypad can control and F05 setting has
no effect.
When C41=001: only VR on the keypad can control and F05 setting has no effect.
• Remote mode
Run command from Run parameter (F04) control setting
Frequency command from Frequency parameter (F05) control setting
•Remote/Local change mode on keypad is achieved by simultaneously pressing /RESET and
VALUE
VALUE
DATA
ENT
DATA
ENT
Output voltage
DC voltage
Output current
PID Feedback
DSP
FUN
DSP
FUN
F10=001, inverter
displays status
DSP
FUN
F
×
F
×
××
××
^
V
After
0.5s
DATA
ENT
DATA
ENT
Power ON
˙
˙
˙
~
DSP
FUN
DSP
FUN
DSP
FUN
RUN
STOP
RUN
STOP
Blinking output
frequency in run mode
^
VV
VALUE
VALUE
DSP
FUN
DSP
FUN
DATA
ENT
DATA
ENT
Figure 2-1 Keypad Operations Sequence
Frequency display
in stop mode