Installation Guide

3 4
ESF-WH-071 ESF-WH-071
Step 1: Remove the pipe cap from bottom. Step 2: Thread the wire through the central
hole in the base
Step 3: Screw into the base.
Step 4: Connect the circuit wires to the fixture
wires using wire nuts and electrical tape for
a more secure connection.
Ceiling mount: Type 2 : Wires from Conduit
Wall mount: Type 1: Wires from bottom hole
Wall mount: Type 2: Wires from Pipe
When installed on the outdoor side wall,
the inside bend pipe of this part can prevent
water flow in from the wall seam
Keep 45° angle
between screw
and pipe holes
Keep 45°angle
between screw
and pipe holes
Waterproof
plaster
Waterproof
plaster
45°
45°
Made in China
Step 5: Tighten the screws and insert end
caps, adjust the bulb to the angle you want,
then lock.
Step 1: Drill two holes and install the
mounting base.
Step 4: Tighten the screws, insert end caps,
and adjust fixture mounting base.
Step 2: Insert the wire conduit into the
mounting base.
Step 3: Connect the circuit wires to the fixture
wires using wire nuts and electrical tape for a
more secure connection.
Step 4: Tighten the screws and insert end
caps, adjust the bulb to the angle you want,
then lock.
Step 1: Tighten the bottom hole mounting
and aim it with the upper hole.
Step 3: Connect the circuit wires to the fixture
wires using wire nuts and electrical tape for a
more secure connection.
Step 2: Insert the wire conduit into the
mounting base.