String Trimmer Manual

14
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Trimmer runs slowly
Check that the spool housing can
rotate freely
Carefully clean it if necessary
Check that the cutting line does not
protrude more than approximately
5-3/8 inches (136mm)
from the spool.
If it does, cut it o so that it
just reaches the line trimming
blade.
Unit will not start
Battery not installed properly Check battery installation
Battery not charged
Check battery charging re-
quirements
Battery will not charge
Battery not inserted into charger
Insert battery into charger
until red LED appears
Charger not plugged in
Plug charger into a working
outlet.
Check current at receptacle
by plugging in a lamp or other
appliance.
Check to see if receptacle is
connected to a light switch
which turns power o when
you turn out the lights.
Surrounding air temperature too
hot or too cold
Move charger and tool to a
surrounding air temperature of
above 40 degree F (4.5°C) or
below 105 degree F (+40.5°C).